We recommend spindle design changes or enhancements to improve spindle longevity and/or performance.
Have a great week end and up and coming holiday. I am writing to thank Northland Tool for going the extra mile and saving my company from expensive machine downtime and expensive repairs. Experience and quality workmanship of the repair technician. Great job guys! Watch. Facilities also located in IL, NC and Mexico, Call: 603.669.5993 Thank the Northland team for us for a job well done . Incoming vibration analysis is performed in order to determine: bearing condition, level of unbalance, non-repetitive runout. He will identify the mode of failure and all pertinent issues, as well as recommended corrective actions. Our repairs will typically cost 1/2, or less than 1/2 the price of a new spindle. Trusted by Customers and Companies Worldwide.

Predictive maintenance services ensure that you catch any problems with your spindle before they become incredibly costly. Removal can be done either by the customer themselves or by GTI technicians who can be sent to the client’s site for removal of the spindle. Join them. The condition of the machine before the rebuild along with accurately diagnosing any and all problems. The detailed cause of failure reports and the expert technical advice that Northland Tool provides is bar none the best I have ever seen. Call us to arrange your Komo spindle repair and to get your spindle back into production. The taper runout is acceptable. We keep bearings in stock for these motors to allow us to keep pace with our repair volume.

Call us to arrange your Komo spindle repair and to get your spindle back into production. For more information on an item, contact the seller directly. We have repaired it. The first spindle we performed this on is still in the machine running like new after 3 years. The stator passed the phase and insulation tests. Hope everything is ok there. Upon arrival, every spindle is logged into our production tracking software system. When this Komo RV 154.22 spindle arrived at Northland Tool and Electronics we completed a full breakdown and evaluation of the spindle. New and Used KOMO - We have 19 listings for KOMO listed below. We have sent several spindles to you and have nothing but great things to say. The upper and lower bearings show some wear on the inner and outer diameters. More importantly, we have full access to parts as well as complete manufacturing capabilities that allows us to repair your machine tool spindle properly the very first time.

When more than one component of your spindle is not operating properly it can be overwhelming—especially when you expected that you’d only need a repair. You performed a miracle with my BIG PLUS spindle. In the past other spindle repair vendors talked a big game and consistently failed to deliver. After Northland fixed the housings the spindles have never sounded as good or run as well! We have always sent our Chiron spindles for repair as a shaft with bearings. Upon initial inspection,… Komo VMC50/160 Spindle Repair. The proximity switches work fine and will be set at time of assembly. New parts to original design specifications will be installed by our Service Technicians for complete unit responsibility. Northland Tool and Electronics is equipped to support any type of Komo spindle repair. Comparison of parts to detailed prints, when required, ensures that no corners are cut. We discussed this in detail and mutually decided to modify the spindle shaft to prevent this from occurring again. After crashing the spindle severely damaging the taper we found that a replacement spindle was not only cost prohibitive but had a long delivery. Re-balancing is critical, even on “simple bearing replacement repairs.”. Free shipping. The drawbar is tested to ensure proper locking of the tool holder and the unit is shipped. We have state-of-the-art in-house resources and manufacturer trained technicians, so that you’ll find that your repaired spindle will be better than new. We offer both in-house and on-site spindle repairs, as well as emergency assistance for when you absolutely need to get your spindle back up and running immediately.